Pay in 4 interest-free payments of $7.50 Learn more
Ships within 48 hours · Estimated delivery Sep 22 - Sep 27
Features the same 24v requirements as the Daylight
*Note* Please pay special attention to the pinout of the fans polarity to avoid fan damage from incorrect wiring
extruder motor and the X-endstop into a single 14 pin Micro-Fit 3
This board converts the logic level STEP and DIR outputs on a Stepstick header to 5V level for properly driving 2 Neopixel strips
Trace widths
KUSBA by xbst_Isik KUSBA Features the same 24v requirementsA PCB designed to make Klipper's input shaping much easier by simplifying the wiring and config for measuring resonances. You just need this PCB and a USB C cable. These come preflashed with Rampon firmware. These should not need a new flash. More info can be found here: KUSBA
US$ 15.00
US$ 10.00
US$ 2374.00
US$ 30.00
US$ 40.99
US$ 10.00
US$ 1024.50
US$ 1716.50
US$ 2816.50