Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test) Ingestion-build-71203 The aim of this standard

The aim of this standard is to standardize the terminology and symbols used in project management to facilitate communication and the spread of knowledge of the subject

7 Collector identification

standardized test conditions

As a defence

Research and experimentation laboratories

Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test) Ingestion-build-71203 The aim of this standard1 Scope This International Standard specifies a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of dn 63 mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long term application of a constant and longitudinally applied force. The susceptibility of the polyolefin pipe to stress crack failure initiated by the joint assembly is also examined. NOTE For