CARPRO Eraser Fittings and Parts Inlet = 1/4" (National Pipe

Inlet = 1/4" (National Pipe Thread) NPT Male:  This 1/4" male threaded end screws into a female 1/4" connection

but I think it's worth every penny

put the cartridges back inside the housings and reattach them to the body of the unit

While this was happening

if you visit our location you'll probably see at least half of our employees sporting a basic shirt

CARPRO Eraser Fittings and Parts Inlet = 1/4" (National PipeOil and Polish Remover I can't recall exactly when I made the switch to this, but I'm a huge fan of this stuff. The main use for this is to dissolve remove oils left behind after polishing. I use it after compounding to make sure I'm getting a clear view to check my work before moving on to finishing. It also ensures the oils from the compound aren't interfering with your next polishing step. Then we use it again after all polishing is complete to